This week is about experience, problem and progress be issue be relate to produce my FYP 2 project.
Hardware Development
Hardware development in this project be
inspired follow figure 3.5 for the start and end of the project. Based on the
figure show position of the hardware component be assembly as one complete
system.
The basic procedure in any can of project is to
understand and learn the concept before proceed to the circuit. In the project
require hardware like Arduino, RFID card and it reader, GSM module and reed
switch. Based on the diagram 3.6, the
system has been compiled and connect to each of hardware to produce a complete
correct circuit.
The circuit schematic of the product will be the
guidelines for the complete connection circuit. The figure 3.6 show a finish
process from design to construct.
RFID reader module is simultaneously
communicated with the extensive type of tag however one tag isn't always
communicated with the huge type of RFID reader module and all the movements be
record and give a message or notification to the user through his/her handphone
in which give information about his/her car by present of GSM module.
Comments
Post a Comment